1 OF 3
INSTALLATION SHEET
Operaon Overview
Wall Washers can be operated in two ways:
1) Independently (One or more xtures): Primary xture operang independently or commanding addional xtures.
2) With a DMX Controller: One or more wall washers commanded by a DMX controller.
Before you begin, read all warnings and installaon instrucons thoroughly.
Safety & Warnings
• Turn power OFF at main breaker before servicing or installing this product.
• This product is intended to be installed and serviced by a qualied, licensed electrician.
• Install in accordance with the Naonal Electric Code, and local regulaons.
• Install in a well-venlated, combuson-free environment.
• Do not disassemble or modify this product beyond these instrucons. Doing so will void your warranty.
• This xture is not compable with any tradional dimming controls. Wall washers can only be controlled/dimmed with the on-board interface or
with an external DMX controller. Please contact customer service for addional informaon.
• Ensure all adjusng screws on mounng brackets and xtures are properly secured prior to installaon.
• THIS FIXTURE IS INTENDED FOR FLOOR MOUNTING ONLY. DO NOT MOUNT TO WALLS OR CEILINGS.
• This xture is rated for indoor installaon only and is IP 20 rated.
• It is recommended to power this xture by a GFCI protected circuit.
• This xture is only UL Listed for connecon with a 120VAC, 15- or 20-ampere branch circuit.
• This xture is not to be used in or around chlorinated, treated or salt water due to the corrosive and degrading qualies of chlorine, saline, and other
chemicals on the xture components. Keep at least 16 feet away from pools and spas.
• This xture is rated for use in an environment where the ambient operang temperature is -4° ~ 104° F (-20° ~ 40° C).
INDOOR WALL WASHERS
LINAIRE™ Wall Washer
1/4” mounng holes
A B
Address Menu
Fig. 1a
Field 1 Field 2 Field 3
A B
Field 1 Field 2 Field 3
Funcon (P) Menu
Fig. 1b
P63
Mounng
Each wall washer has its own on-board control pad and 3-digit display, operated by two menu buon
controls – ‘A’ and ‘B’. Buon ‘A’ cycles through the 3-digit display and switches the display from the
Address Menu (Fig. 1a) to the Funcon (P) Menu (Fig. 1b). Pressing Buon ‘B’ connually changes the
desired value of each eld.
At startup, the wall washer will always be set in the Address Menu. To switch to the Funcon (P) Menu
(Fig. 1b), press Buon ‘A’ once and Field 3 will begin to ash. Press Buon ‘A’ three mes to be directed
to the Funcon (P) Menu. Once in the Funcon (P) Menu, press Buon ‘A’ two mes to switch back to
the Address Menu.
Note: this xture is intended for oor mounng only. Do not mount to walls or ceilings. Ensure xture is properly mounted and
all adjusng screws are properly secured prior to permanent installaon. All xtures must be individually powered by 120VAC.
Commentaires sur ces manuels